Qlogic Fibre Channel Switch Event Message Manual page 69

A
(C) (8400.008F) (Attempted speed licensed upgrade that is already enabled)
Meaning:
(C) (8400.0096) (Secondary CPU firmware update complete)
Meaning:
(C) (8600.0009) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning:
(C) (8600.000A) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning:
(C) (8600.000B) (PortApp) (Port: port_number) (Link reset (LR) to be performed on port
port_number.)
Meaning:
(C) (8600.0013) (PortApp) (Invalid vendor data from media device for port port_number)
Meaning:
(C) (8600.0014) (PortApp) (Invalid vendor data from media device for port port_number)
Meaning:
(C) (8600.0015) (PortApp) (Unresponsive device alpa on port port_number removed from
the fabric.)
Meaning:
(C) (8600.0016) (PortApp) (Online port(s) port_numbers were reset due to disruption during
hot reset.)
Meaning:
59060-06 A
An attempt was made to install a license for a port speed that is
already operable on the switch.
The update of the firmware image on the secondary CPU is
complete.
The port will perform a link reset (LR) due to a loss of credit
problem.
The port will perform a link reset (LR) due to a loss of credit
problem.
The port will perform a link reset (LR) due to loss of credit issue.
The switch could not read and verify the media module ID. This
may indicate a discovery error or a bad checksum in the serial ID.
Other possibilities include an improperly installed media module or
an internal media I/O hardware fault.
The switch could not read and verify the media module ID. This
could be caused by a media discovery error, a bad checksum in
the media serial ID, an improperly installed media, or an internal
media I/O hardware fault.
A device on the loop port did not take an OPN primitive off the loop
destined for it. This suggests the device either has been physically
removed or is faulty. In addition, it has been removed from the
fabric nameserver.
Some ports were disrupted during the hot reset operation.
3 – Event Messages
Critical Events
3-57