Qlogic Fibre Channel Switch Event Message Manual page 66

3 – Event Messages
Critical Events
(C) (8400.0060) (Switch) (Warning-Illegal transparent mode configuration, primary and
backup cannot be mapped to the same port. Port port_number 's backup
mapping has been deleted.
Meaning:
(C) (8400.0061) (Switch) (Warning-Illegal transparent mode configuration, Either the
primary or backup map for port port_number was set to a port whose type is
not TF. The mapping for this port has been cleared.
Meaning:
(C) (8400.0062) (Switch) (New firmware has been installed.)
Meaning:
(C) (8400.0065) (Switch) (The switch is being automatically hardreset after leaving the
Diagnostics AdminState.)
Meaning:
(C) (8400.0066) (Switch) (IOn) (Blade is being automatically hardreset after leaving the
Diagnostics AdminState.)
Meaning:
(C) (8400.0067) (Switch) (The switch is entering Diagnostics AdminState and will
automatically hardreset and have the configured AdminState when leaving
the Diagnostics AdminState.)
Meaning:
(C) (8400.0068) (Switch) (IOn) (Blade is entering Diagnostics AdminState and will
automatically hardreset and have the configured AdminState when leaving
the Diagnostics AdminState.)
Meaning:
3-54
When mapping TH ports to TF ports, the primary and backup TF
ports cannot be the same for a given TH port.]
An attempt was made to map a TH port to a port that was not of
type TF.
New firmware was successfully installed.
The switch automatically undergoes a hard reset after leaving the
Diagnostics administrative state.
I/O blade is undergoing a hard reset after leaving the Diagnostics
administrative state.
The switch is entering the Diagnostics state and will automatically
undergo a hard reset. The switch will return to the configured
administrative state after leaving the Diagnostics administrative
state.
The I/O blade is entering Diagnostics state and will automatically
undergo a hard reset. The I/O blade will return to the configured
administrative state after leaving the Diagnostics administrative
state.
S
59060-06 A