Qlogic SANsurfer FC HBA Manager User Manual page 128

Troubleshooting
Verifying that qlremote is Installed and Running
To verify that qlremote is installed and running on Red Hat/SUSE Linux:
1. Type one of the following commands and then press ENTER:
# ps ax | grep qlremote
# ps -ef | grep qlremote
2. If entries display, qlremote is loaded.
Alternate Linux procedure:
1. Change to the following directory:
cd /usr/local/bin
2. Type the following command and then press ENTER.
./qlremote -v
3. Verify that the appropriate network protocol is running.
To verify that qlremote is installed and running on Solaris SPARC/x86:
1. Type the following command and then press ENTER:
ps -e | grep qlremote
2. If entries display, qlremote is running.
Alternate Solaris procedure:
1. Go to the SANsurfer installation folder.
2. Type the following command and then press ENTER:
./qlremote -v
3. Verify that the appropriate network protocol is running.
To verify that qlremote is installed and running on Macintosh:
1. Type one of the following commands and then press ENTER:
# ps ax | grep qlremote
# ps -ef | grep qlremote
2. If entries display, qlremote is loaded.
7-14
S
SN0054651-00 G