Qlogic SANbox2-16 Fibre Channel Installation Manual page 121


The following is an example of the Set Config Zoning command.
SANbox2 #> admin start
SANbox2
SANbox2
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
AutoSave
Default
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
59021-05 A
(admin) #> config edit
(admin-config) #> set config zoning
(True / False)
(All / None)
[True]
[All ]
B – Command Line Interface
Set Config Command
B-33