Power Supply Removal; Power Supplies - Qlogic SANbox2-16 Fibre Channel Installation Manual


6.2

Power Supplies

The power supplies are hot pluggable. This means you can remove or install one
of the power supplies while the switch is operating without disrupting service. The
power supplies are also interchangeable; that is, the left and right power supplies
are the same unit.
To remove the power supply, grasp the power supply latch handle and pull firmly
to release the latches and disengage the modular connector. Slide the power
supply out of its bay as shown in
To install a power supply, slide the power supply into the bay with the latch handle
on top. Press the power supply firmly into place until it is fully seated, then push
the latch handle in against the power supply to engage the latches.
Latch Handle
59021-05 A
Figure
Figure 6-2. Power Supply Removal
6 – Removal/Replacement
6-2.
Power Supplies
6-3