B-9 Set Config Threshold Parameters - Qlogic SANbox2-16 Fibre Channel Installation Manual

B – Command Line Interface
Set Config Command
PrincipalPriority
ConfigDescription
threshold
Initiates a configuration session by which to generate and log alarms for selected
events. The system displays each event, its thresholds, and sampling interval one
line at a time and prompts you for a value. For each parameter, enter a new value
or press the Enter key to accept the current value shown in brackets. These
parameters must be saved in a configuration and activated before they will take
effect. Refer to the
and activating a configuration.
parameters. The switch will down a port if an alarm condition is not cleared within
three consecutive sampling intervals (by default 30 seconds). An alarm is cleared
when the threshold monitoring detects that the error rate has fallen below the
falling threshold.
Threshold Monitoring Enabled
CRCErrorsMonitoringEnabled
DecodeErrorsMonitoringEnabled
ISLMonitoringEnabled
LoginMonitoringEnabled
LogoutMonitoringEnabled
LOSMonitoringEnabled
B-28
Table B-8. Set Config Switch Parameters (Continued)
Parameter
"Config Command" on page B-7
Table B-9
Table B-9. Set Config Threshold Parameters
Parameter
Description
The priority used in the FC-SW-2
principal switch selection algorithm. 1 is
high, 255 is low.
The name for the configuration. The
default is undefined.
for information about saving
describes the Set Config Threshold
Description
Master enable/disable parameter for all
events. Enables (True) or disables (False)
the generation of all enabled event alarms.
The default is False.
The event type enable/disable parameter.
Enables (True) or disables (False) the
generation of alarms for each of the
following events:
CRC errors
Decode errors
ISL connection count
Login errors
Logout errors
Loss-of-signal errors

59021-05 A