Qlogic SANbox2-16 Fibre Channel Installation Manual page 118

B – Command Line Interface
Set Config Command
Examples
The following is an example of the Set Config Port command:
SANbox2 #> admin start
SANbox2
SANbox2
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
TLPortMode
ISLSecurity
SymPortName
ALFairness
ARB_FF
InteropCredit (decimal value, 0-255)
ExtCredit
FANEnable
LCFEnable
MFSEnable
MFS_TOV
MSEnable
NoClose
I/O Stream Guard -
VIEnable
CheckAlps
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
B-30
(admin) #> config edit
(admin-config) #> set config port 1
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]
(1=1Gb/s, 2=2Gb/s, 3=Auto)
(TL / GL / G / F / FL / Donor)
(1=TLTargetMode, 2=TLInitiatorMode)
(Any / Ours / None)
(string, max=32 chars)
(True / False)
(True / False)
(decimal value, 0-65535)
(True / False)
(True / False)
(True / False)
(decimal value, 10-20480 msec)
(True / False)
(True / False)
(Suppress RSCN)(Enable / Disable)
(True / False)
(True / False)

[Auto ]
[GL ]
[TLInitiatorMode]
[Any ]
[Port2 ]
[False ]
[False ]
[0 ]
[0 ]
[True ]
[False ]
[False ]
[640 ]
[True ]
[False ]
[Disable]
[False ]
[False ]
59021-05 A