Speaker Connections - Yamaha RX-V1400 Owner's Manual

_ @0(t RX-VI400U EN.book Page 77 Thursday, July 10, 20(13
12:17 AM
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit 1o the standby mode, disconnect the power cord, and contact the
nearest authorized YAMAHA dealer or service center.
• General
+
Problem
This unit fails to turn
on when STANDBY/
ON (or SYSTEM
POWER) is pressed,
or enters in the
standby mode soon
after the power has
been turned on.
On screen display
does not appear.
No sound
No picture
Cause
The power cord is not connected or the
plug is not completely inserted.
Tile impedance setting is incolTeCt.
Tile protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
Tile setting for the on-screen display is set
to "DISPLAY OFF".
GRAY BACK in the SET MENU is set to
OFF, and no video signal is currently
being received.
Incorrect input or output cable
connections.
INPUT MODE is set to DTS or
ANALOG.
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
Tile volume is turned down.
Tile sound is muted.
If you are playing an LD som'ce, the
player may not output digital signals if the
LD source was not digitally recorded.
Tile INPUT MODE is set Io ANALOG
while playing a som'ce encoded with a
DTS signal.
The signals this unit cannot reproduce are
being received from a source component
e.g.: a CD-ROM.
The output and input tk)r the picture are
connected to dirt?rent types of video
iacks.
Refer to
Remedy
page
Connect the power cod
firmly. ----
Set the impedance to malch your speakers.
Make sure al! speaker wire connections on this unit
and on all speakers are secure and that the wire tbr
each connection does not touch anything other than
its respective connection.
Set this unit in the standby mode, disconnect the
power cord, plug it back in after 30 seconds, lhen use
it normally.
Select the fall or ShOll display mode.
Set GRAY BACK Io AUTO to always show the OSD.
Connect the cables properly. If the problem persists,
the cables may be det?ctive.
Select AUTO.
Select an appropriate input source with INPUT,
MULTI CH INPUT or the input selector buttons.
Secure the connections.
Select the front speakers with SPEAKERS A and/or
B.
Turn up the vOlulne.
Press MUTE or any operation buttons of this unit to
cancel a mute and adjust the volume.
Set lhe INPUT MODE to ANALOG.
Set lhe INPUT MODE to AUTO or DTS.
Play a source whose signals this unit can reproduce.
Turn on the video conversion function.
23
12--14
44
56
16--19
34
30
12
30
31
34
34
56
+
77