Yamaha RX-V1400 Owner's Manual page 26

_ @00 RX-VI400U EN.book Page 22 Thursday, July 10, 20(13
12:17 AM
rolo]_l_lgglStlgOlLql
• Connecting the AC power cord
(U.S.A. and Canada models)
Plug the power cord into the AC inlet after all other
connections are complete, then plug the power cord to an
AC wall outlet.
+
(U.S.A. model)
VOLTAGE SELECTOR
Do not use other AC power cords. Use the one provided.
Use of other power cords may result in fire hazard or
electrical shock.
(Other models)
Plug the power cord into an AC wall outlet.
• AC
OUTLET(S) (SWITCHED)
U.K. and Auslralia models .............................. 1 OUTLET
Korea model ............................................................... None
Other models .................................................. 2 OUTLETS
Use these outlets to connect the power cords from your
other components to this unit. Power to the AC
OUTLETS(S) is controlled by this unit's STANDBY/ON
(or SYSTEM POWER and STANDBY). These outlets
will supply power Io any connected component whenever
this unit is turned on. The maximum power (tolal power
consumption of components) that can be connected to the
AC OUTLETS(S) is:
Asia and General models .......................................... 50 W
Korea model ................................................................. N/A
Other models ........................................................... 100 W
• VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE plugging
into the AC main supply. Voltages are 1101120/220/230-
240 V AC, 50/60 Hz.
•
Memory back-up
The memory back-up circuit prevents the slored data from
being lost even if this unit is in the standby mode.
However if the power cord is disconnected from the AC
wall outlet, or the power supply is cut for more than one
week, the stored data will be lost.
+
(General models)
22