Yamaha RX-V1400 Owner's Manual page 60

_ @0B RX-VI400U EN.book Page 56 Thursday, July 10, 20(13
12:17 AM
Video conversion
U CONU.
Use this feature 1o turn on!off the conve_sion of composile
signals to both S-video and component signals. This
I IF I ! J! h_!'il.i
÷ A>DISPLAY SET
B>FIENORY GUARD
C>PARAM. INI
D>ZOHE SET
/+ _ Enter ¸
) - * iI
•
Displayset [I:,FLA,
SET
MANUAL SETUP > OP770N MENU > DISPLAY SET >
allows you m oulput composite signals from the S-video
jack or the component video jack when no S-video or
component signals are input. This feature also converts S-
video signals 1o component signals when no component
signals are input.
Choices: ON, OFF
• Select OFF not to convert any signals.
• Select ON 1o convert composile signals to S-video and
component signals, and lo convert S-video signals to
component signals.
+
M,<L.<I.,r .'d
÷ DIMMER.........
6
BSB SHIFT ......
@
BRA'?BACK...AUTO
B COMB........OH
CMPHT OSB....OFF
-_÷ _ Selemt
Dimmer DIMMER
Use 1o adjust the brightness of the front panel display.
Choices: _4 to 0
OSDshift
OSD SHIFT
Use 1o adjust the vertical position of the OSD.
Choices: +5 (downward) to -5 (upward)
• Press + to lower the position of the OSD.
• Press - to raise the position of the OSD.
Gray back GRA'v' E,_4.+.
Selecting AUTO for the on-screen display setting displays
a gray background when there's no video signal input.
Nolhing is displayed if OFF is selecled.
Choices: AUTO, OFF
If "GRAY BACK" is set to OFF, no information will be displayed
on the screen when video signals are not being input.
• Converted video signals are only output to the MONITOR OUT
jacks. When recording yon must make the same type of video
connections (composile or S-video) between each component.
• When converting S-video signals fi'om a VCR m component
video signals, the picture quality may su f_r depending on your
VCR.
Component OSD DMPMT OSD
Use this fealure
1o tm'n on!off OSD oulput 1o the
COMPONENT VIDEO MONrI'OR OUT jacks when
using the set menu, lest tone or parameter functions.
Choices: ON, OFF
• Select ON to output the OSD signals from
COMPONENT VIDEO MONITOR OUT jacks.
• Select OFF if you do nol want to oulput the OSD
signals from COMPONENT VIDEO MONITOR OUT
jacks.
Set menu fimctions even when OFF is selected.
"1
•
Memory guard bIEM._ GUnRD
Use this fealure to prevent accidental changes to DSP
program parameler values and olher syslem settings.
MANUAL SETUP > OP770N MENU > MEMORY
GUARD >
Z# I'IZI'IL_X _3L_NN_'
_OFF OH
+
i,'v : Exit
Choices: ON, OFF
Select ON to protect:
• DSP program parameters
• All SET MENU ilems
• All speaker levels
• The on=screen display (OSD) mode
When MEMORY GUARD is set to ON, you cannot use
the test tone or select any other SET MENU items.
56