Front Panel Display - Yamaha RX-V1400 Owner's Manual

_ L] @00 RX-VI40(IU EN.book Page 23 Thursday, July 10, 20(13
12:17 AM
Ipl_%,l_*lll[OATl
[*_I#JuffeJ_
If you are using 6 ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while pressing down
SPEAKERS A, press STANDBY/ON.
"SP IMP.SET" appears on the front panel display for
a few seconds, then "Minimum 8ohms" appears.
ASPEAKEAS
When all connections are complete, turn on the power of
this unit.
-
_--F= j.!!F = =-r'T
1
N :
"
=-'- .'. Z -
2 Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
+
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
.%,:
You can also use SP IMRSET (see page 57) to set the speaker
impedance.
(U.S.A. model)
Press STANDBY/ON (SYSTEM POWER on the
remote control) to turn on the power of this
unit.
SYSTEM
POWER
or
Frontpanel Remotecontrol
2 Turn on the video monitor connected to this
unit.
+
23