Yamaha RX-V1400 Owner's Manual page 73

_ @00 RX-VI400U EN.book Page 69 Thursday, July 10,20(13
12:17 AM
Using this unit's internal amplifier
"Ib use Ihis unit's internal amplifier, select ON in ZONE2 AMP.
Second room
This unit
+
The supplied remote control can be used to control Zone
2/Zone 3. You can even select the input source and control
components located in the main room directly from the
second room regardless of the listening condition in the
main room.
• To enable Zone mode on the remote
control
You will be able to switeh the remote control mode from
one morn to another, and use STANDBY, SYSTEM
POWER, MUTE and VOL -/+ to control Ihe selected
room.
1 Repeat steps 1 and 2 of the procedure in
"Setting manufacturer codes" on page 60.
2 Press (/) to select "L:AMP".
12!!!HP
3
Press A / v to select "ZONE".
• To control Zone 2/Zone 3
Press SELECT A repeatedly to display
"ZONE2" or "ZONE3" in the display window.
2 Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
3
Press an input selector button to select the
input source you want to listen to in the
second/third room.
The display window shows "2: name of selected
input" if the remote control is in the Zone 2 mode.
PH_{_ TUNE_ Q_)
+
"_ • UI"t •
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
4
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit,
Zone 2 or Zone 3.
69