Yamaha RX-V1400 Owner's Manual page 29

_ _0(! RX-VI400U EN.book Page 25 Thursday, July 10, 20(13
?
12:17 AM
For best resulls, make sure the room is as quiet as possible
during the aulo setup procedure. If there is Ioo much
ambient noise, the results may not be salisfaclory.
g&.
If your subwooter can adjust the output volmne and the crossover
frequency, set
the volume to about half way
(or slightly less)
and
set the crossover frequency to the maximum.
1
2
Switch on the receiver and video monitor.
Make sure the OSD is displayed.
Press AMP to select the AMP mode, then
press SET MENU to enter the SET MENU.
St_ENU
then
3 Press A / V to select AUTO SETUP, then
press > once to enter the main menu.
+
€
_i- T ]_
D_! Hr-hU
÷ ,_UIO _.:,fi:f UP
• M_NUAL _ fi:IUP
€
4
Press A / V repeatedly to select WIRING,
DISTANCE, SIZE, EQUALIZING or LEVEL.
HUiU:H_i]U
L'_I S T_NCg • __C_ECK
glzE ..... CHECK
E,., _LI_ IN,_ , L_T
LE_gL.....
CHECK
SETUP ....... _uYO
START F'HSH +
5
6
7
When WIRING, DISTANCE, SIZE or LEVEL is
selected, press ( / > to select:
CHECK To automatically check and adjust the selected
item.
S_::I P To skip the selected item and perform no
adjustments.
g&.
When using THX speakers, set SIZE m SKIP and make sure
that SMALL or SMLx2 is selected in SPEAKER SET
(page 49) and that 80Hz is selected in CROSS OVER
(page 50).
When EQUALIZING is selected, press ( / > to
select:
FRONT "Ib adjust the frequency response of
each speaker in accordance with the
sound of your front speakers.
Recommended if your front speakers
m'e of much higher quality than your
other speakers.
FL_T
"Ib average the frequency response of
all speakers. Recommended if all of
your speakers are of similar quality.
L01.,.I "Ib average the frequency response of
all speakers, giving priorily to the
accuracy of bass frequencies.
MI 0 "Ib average the frequency response of
all speakers, giving priorily to the
accuracy of mid-range frequencies.
H I GH To average the frequency response of
all speakers, giving priorily to the
accuracy of high frequencies.
Sk:: I P
To skip the seleeled item and perform
no adjustments.
Press v to select SETUP, then press < / > to
select:
nUTEI "Ib aulomatically perform the entire
aura setup procedure.
STEP "Ib pause for confirmation between
each check in the aulo setup procedure.
RELOAD
"Ib restore the last auto setup setting.
Press v to select START PUSH +, then press
>.
Loud test tones will be output from each speaker and
WAIT appem_sduring the auto setup procedure.
+
25