Select Integration Value; Configure Status - Fluke NORMA 4000 Operator's Manual

In the Integration Setup menu, define the following settings:
Line
En/Start
Clr/Stop
Val 1..3
Val 4..6
Menu Integration Setup is displayed on the screen.

Select Integration Value

1. Select with the cursor in line Val 1..3 or Val 4..6 a value and press Enter.
A dialog window showing the selectable values is displayed.
2. Move the Cursor in the window to the wanted value and press Enter to confirm.
The parameter is now shown on the display.
3. Configure the other values accordingly.
4. Save the configuration settings by pressing the SAVE function key.

Configure Status

In this menu you can enable / disable the integration function. Also the way of clearing
the values can be configured. This is done in the Integration Setup menu at column State.
Line
En
Clr
Menu Integration Setup, first field column State is highlighted.
1. Press Enter, select ON and confirm with Enter.
The integrations function is now enabled. If you want to disable it, select OFF
and press Enter to confirm.
2. Save the configuration settings by pressing the SAVE function key.
The integration function is enabled (ON) in the factory configuration 1:W3.
Enable integration function/ set start conditions
Configure data reset / set stop conditions
Select first three values
Select next three values
Settings
ON
OFF
MAN
AUTO
Note
Integration Function Configuration
Function
Description
Integration function active
Integration function inactive
Clear manual
Auto clear at start
7
Configuration
esn029.eps
7-21