The default address is 0.0.0.0 (factory settings). Addresses can only be
entered in conjunction with IP network addressing (for example, address
193.0.255.4).
Network addresses are available from your network administrator.
Configure Average Time and Synchronization
This configuration concerns important parameters required for the synchronization of the
measuring procedure. To configure these parameters, proceed as follows:
Call up "Timing & Sync" Setup
Enter average time
Select synchronization source
Set trigger level
Select slope direction
Select low-pass filter
Configure signal output
Timing & Sync Setup
Move the cursor to menu item Timing & Sync Setup and press Enter.
The "Timing & Sync Setup" menu is displayed. The value in column Tavg[s] is
highlighted.
Configure Average Time and Synchronization
Note
Note
7
Configuration
esn020.gif
7-9