Set Frequency Range; Change View Mode - Fluke NORMA 4000 Operator's Manual

NORMA 4000/5000
Operators Manual

Set Frequency Range

The default frequency range is set to a maximum of half the sampling frequency.
For signals with a lower frequency (for example, 10 Hz), the frequency
range must be adjusted; otherwise, the measurements would be inaccurate.

Change View Mode

You have the option to view individual measured values or a group of up to three values
(that is, all measured values of channel 1) in graphic or table format. By default, the
measured values are shown in graphic format.
8-22
The details of measured value I1 (current) are displayed.
3. Press function key Detail again.
The details of measured value P1 (power) are displayed.
4. To return to the overview of measured values of the selected channel, press
function key Detail again.
1. Press function key Freq.
A list of possible values is displayed.
2. Select a value, using the cursor keys, and press Enter.
The frequency analysis is carried out up to the selected value, and the result is
displayed.
1. Press function key tab/gra.
The raw data is now shown in a table (shown here, voltage on channel 1).
Note
esn053.gif