Extreme Networks EPICenter Guide Manual page 53

Figure 20: The Scope tab of the New Alarm Definition window
NOTE
For convenience in scoping alarms, you may want to consider creating special-purpose device groups or port groups,
and use those in your alarm scope. The benefit is that you can change the scope of the alarm simply by changing
the membership of the relevant group. You will not need to modify our alarms every time you add, move or change
elements in your network —adding or removing ports or devices from the relevant devices groups will be sufficient.
3 Click the Action tab, and do the following:
a Click the Forward trap to: check box to turn on the check.
When the checkbox is checked, a line showing the trap receiver configuration is displayed. The
trap receiver is defined by a host name, port, community string, and whether the trap should be
converted to SNMPv1 or SNMPv2c.
The information in the Action tab should look as shown in
EPICenter Concepts and Solutions Guide
Using the EPICenter Alarm System
Figure 21.
53