Extreme Networks EPICenter Guide Manual page 239

To manually update the configurations for the default device group, enter the command:
devcli sync -u admin -g Default
NOTE
You can type either sync or syn when you use the devcli sync command.
These commands support a set of options for specifying device information such as passwords and
community strings, device group information such as device group names and member devices, as well
as information about the EPICenter server, such as host name or IP address, port, and user name and
password. You can also specify multiple IP addresses in a file to have them added or removed as a
group, as long as they all use the same user name, password, and community strings.
Table 11 specifies the options you can use with these commands:
Table 11: DevCLI command options
Option Value
-a Device IP address. This option can be specified more than once.
-b SNMP version 3 user name.
-c Cisco enable password.
-d Device password.
-e Device group description.
-f Input file name for IP addresses. This specifies an ascii file that contains a list of IP
addresses, one per line. No other information can be included in this file.
This option can be specified more than once.
-g Device group to which devices should be added. Case sensitive. The device group must
already exist.
-h Input file name for device groups. This specifies an ascii file that contains a list of
device group descriptions, one per line. A device group description may be included by
enclosing both the device group name and the device group in double quotes. The
quotes sever to delimit the two values.
This option can be specified more than once.
-i Device poll interval, in minutes
-j SNMP version 3 privacy password
-l (Letter l) User name to use for device login
-m New device group name. Use this command when you are modifying a device group
-n EPICenter server port number
-o SNMP version 3 authentication password
-p EPICenter user password
-r Read community string (only needed for adding devices; not needed for deleting them).
-s EPICenter server hostname or IP address
-t SNMP version 3 authentication protocol (none, MD5, SNA)
-u EPICenter user name
-v SNMP version (1, 3)
-w Write community string (only needed for adding devices; not needed for deleting them).
-x Modify device setting (ssh, nussh, offline, online)
-y SNMP version 3 privacy protocol (none, crc)
EPICenter Concepts and Solutions Guide
The DevCLI Utility
Default
None
initialmd5
""
""
None
None
Default
None
0
""
admin
None
8080
initialmd5
""
public
localhost
md5
None
"private"
None
none
239