Chuck Installation - Grizzly g0602 Owner's Manual

chuck installation

to ensure accurate work, it is extremely important
to make sure the spindle nose and chuck mating
surfaces are clean. even a small amount of lint or
debris can affect accuracy.
the chuck is properly installed when it threads
all the way onto the spindle nose (see figure 21
below) and is seated against the spindle shoulder.
figure 21. spindle nose.
tools needed:
Chuck Wrenches ............................................... 2
hex Wrench 5mm .............................................. 1
to install the chuck:
1. disConneCt lAthe FroM poWer!
2. use an appropriate device to protect the ways
and support the chuck during the installation
process (refer to installation & removal
devices on page 26).
3. thoroughly clean, inspect, deburr, and lightly
oil all threads and mating surfaces.
4.
thread the chuck onto the spindle nose and
hand-tighten it.
Model G0602/G0752 (Mfg. Since 11/12)
spindle
shoulder
inside
taper
threads
Qty
5. insert the chuck wrenches as shown in
figure 22, and tighten the chuck until it is
seated snug against the spindle shoulder.
figure 22. location to insert chuck keys when
installing chuck.
6.
install the chuck locks with the cap screws
(see figure 23).
Cap screw
Chuck lock
figure 23. Chuck lock installed on spindle nose
and chuck.
-27-