Assembly; Lubricating Lathe; Power Connection; Connecting Power - Grizzly g0602 Owner's Manual

assembly

With the exception of the handwheel handles, the
lathe is shipped fully assembled.
to install the handwheel handles, thread the large
handle into the carriage handwheel and the small
handle into the cross slide handwheel, as shown
in figure 17.
small
handle
figure 17. handwheel handles installed.

lubricating lathe

GEARBOX MUST
BE FILLED WITH OIL!
LATHE MAY NOT
HAVE OIL INCLUDED!
Refer to the Lubrication
Section in this Manual
for Recommended
Oil Type.
the lathe must be properly lubricated before it can
be operated for the first time.
damage caused to the bearings and gears from
running the lathe without oil in the reservoirs
will not be covered under warranty. refer to the
lubrication section, beginning on page 52, for
details on how to lubricate the lathe.
-22-

power connection

Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the poWer
supply section in this manual, and all previ-
ous setup instructions in this manual must be
completed to ensure that the machine has been
assembled and installed properly.

connecting power

Always make sure the spindle direction switch on
the front of the headstock is turned oFF (middle
position) before connecting power.
insert the power cord plug into a matching power
supply receptacle.

disconnecting power

large
if you need to disconnect the machine from power
handle
for maintenance, service, or adjustments, turn the
machine off and pull the plug completely out of
the receptacle.
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consist of verifying the following: 1)
the motor powers up and runs correctly, 2) the
emergency stop button safety feature works
correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
troubleshooting on page 57.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.

test run

Model G0602/G0752 (Mfg. Since 11/12)