Changing The Id Of A Cm416 Module; System Ethernet Ip Addresses; Changing The Cm416 Id - Euphonix Max Air Control Surface Manual

Euphonix Max Air Control Surface Manual

Changing the ID of a CM416 Module

1. Power cycle the module and then simultaneously press and hold the two lower
knobs on the first strip before the module connects to the System PC (you have
about 15 seconds).
Change ID
2. Set the ID using the first strip only in each CM416. Do not set the ID using strip
nine.
The CM416 displays shows "Position – 0000 Use 1st fader to set module position."
3. Move the fader on strip one to select the ID.
The ID appears as a hexadecimal number (0=ID 1, 1=ID 2, 2=ID 3, 3=ID 4,
4=ID 5, 5=ID 6).
4. Press strip one's fader Select key to commit to the new ID.
The module continues to boot only after committing to the change.

System Ethernet IP Addresses

System Computer
Interface Pilot
Digital Pilot
CM404
CM416
Select Select
On On
Select Select
On On
Select Select
On On
Select Select
On On
Copy Paste Copy Paste
Figure 9 Changing the CM416 ID
ID 9
ID 1
ID 10
Strip 1 ID 1
Strip 9 ID 2
Strip 17 ID 3
Strip 25 ID 4
Strip 33 ID 5
Strip 41 ID 6
15
Select Select Select Select Select
On On On On On
Select Select Select Select Select
On On On On On
Select Select Select Select Select
On On On On On
Select Select Select Select Select
On On On On On
Copy Paste Copy Paste Copy Paste Copy Paste Copy
192.168.0.1
192.168.0.208
192.168.0.200
192.168.0.19
192.168.0.10
192.168.0.11
192.168.0.12
192.168.0.13
192.168.0.14
192.168.0.15
Select
On
Select
On
Select
On
Select
On
Paste Copy Paste