Board, Interface And Printhead Replacements; Replacing The Power/Communication Board (A000368) - FARGO electronics DTC300 Service Manual

RESTRICTED USE ONLY

Board, Interface and Printhead Replacements

Replacing the Power/Communication Board (A000368)

Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See
3 Remove the Input Door and Right End Cap. See
Assembly
4 Remove the Card Output Door and Left End Cap. See
Door Assembly
5 a. Remove the Input Tray.
b. Use a No. 2 Phillips screwdriver to remove the two (2) screws (130984) that
secure the Left End Cap (D900064-01, DTC400; DTC900064-02, DTC300)
to the main assembly.
6 Remove the Printer Baseplate. See
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
Refer to Drawing D900115.
Tools Needed: Torx T-10 Screwdriver, Phillips Head
Screwdriver.
Parts Needed: Power/Communication Board A000368
Estimated Repair Time: 20 minutes.
Replacing the Rear Cover
(D900148). See Replacing the Right End Cap (D900065-01 and
(D900092). See
Replacing the Input Tray
Replacing the Input Door
Replacing the Left End Cap
Replacing the Baseplate
Fargo Electronics, Inc.
(D900066).
Replacing the Output
(D900064).
(D900097).
(D900000).
Continued on the next page
–02).
8-57