Dell Networking 7048 Release Note page 55

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
Release 5.0.0.4
Command
Show snmp filters
Snmp-server filter
aaa authorization {exec }
{default | <list_name>}
method1[method2]
no aaa authorization {exec}
{ default|<list_name>}
authorization exec [default
|<list_name>]
no authorization exec
debug aaa authorization
exec
no debug aaa authorization
exec
Release 4.2.2.3
 No Updates
Release 4.2.1.3
Command
Storm-control broadcast
name "RDU-NOC
Management VLAN"
Release 4.2.0.4

Please refer Dell PowerConnect CLI Reference Guide for more details
System Firmware Version 5.1.0.1
The following note should be added to the command usage guidelines.
When a filter is defined, SNMP treats the filter as having an 'exclude all' statement at
the beginning of the filter. Unless an include statement is specified, all notifications
will be excluded.
The following Exec Authorization CLI commands are missing from the CLI reference
guide
aaa authorization {exec } {default | <list_name>} method1[method2]
no aaa authorization {exec} { default|<list_name>}
authorization exec [default |<list_name>]
no authorization exec
debug aaa authorization exec
no debug aaa authorization exec
The supported syntax is Storm-control broadcast [level rate] where
rate is a parameter to level and defined to be:
The storm-control threshold as percent of port speed. Percent of
port speed is converted to PacketsPerSecond based on 512 byte
average packet size and applied to HW.
If level is not used the default rate is 5.
The VLAN name command has been migrated to VLAN Config mode
and is no longer available in interface VLAN mode.
Issue
Issue
Page 53