Dell Networking 7048 Release Note page 30

general mode The general mode for switchport won't
vlan does not work properly in several cases, such as,
show up after a script apply, nsf failover and save and
reload, it shows reload.
up in access
vlan
SNMP OIDs Walk of any member of
1.3.6.1.4.1.674.1 envMonFanStatusEntry and
0895.3000.1.2.1 envMonSupplyStatusEntry with 67109251
10.7.x causing index causes crash.
switch crash
Stack ARP ARP replies to a routing interface are not
Problem received at the CPU after clearing the
config and reconfiguring the routing
interfaces.
Stack member Stack member unit ports were not displayed
units port properly.
display is
missing in web
GUI.
No response to Third IP fragment was being dropped in
ICMP with jumbo Ping packet.
jumbo (ping)
Ports connected When customer is using the Intel X520
to Intel X520 NICs, sometimes the ports never came back
NIC do not up after a reboot of the switch.
return online
after reboot.
switch reboots switch reboots randomly
randomly
Release 4.2.2.3
Summary User Impact
IP routing Traffic will get forwarded by software when
unexpectedly global routing is not enabled.
after reboot
despite its not
having been
enabled.
Telnet existing "New Telnet Sessions" are changed to
session is Block, All the current telnet sessions are
interrupted closed and using "Telnet Server Admin
when "New Mode" to set Disable will only block new
Telnet Sessions" telnet sessions.
is set to "Block".
OOB interface Out-Of-Band interface will be unreachable
unreachable after a stack failover
after failover
Switch CLI help Warning message printed during execution
does not locate of the deprecated "movemanagement"
the 'initiate command incorrectly
failover' states that "initiate failover" command is
command executed from privileged EXEC mode
properly whereas it's available from stack config
mode only.
28
Corrected memory
initialization problem
Corrected unit number range
check.
Corrected ARP reply policy
problem
Corrected power LED element
id name problem which was
causing this display problem.
Corrected jumbo Ping packet
problem.
Corrected port configuration
timing issue.
Corrected memory corruption
problem.
Resolution
Correct the default action so
that global forwarding is
enabled for the hardware.
Functionality was corrected so
that "New Telnet Sessions"
will only block new telnet
sessions and "Telnet Server
Admin Mode" will close all
the sessions if the mode is
Disabled.
Corrected MAC address for
new manager.
Corrected the warning message
System Firmware Version 5.1.0.1
All
All
All
PCM8024-K
All
PC8024
PC8024F
All
Affected Platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
PCM6220
PCM6348
PCM8024
PCM8024-k
All 4.2 supported
platforms