Dell Networking 7048 Release Note page 35

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
Dropped VLAN Customer is really not able to use this
frames are counter to monitor their network outage
included in activity.
Discards
counters.
PC7048 Combo Combo ports are randomly not transmitting
ports are not traffic, but receiving frames when media
passing traffic. type preference set as SFP
Order of The "show running-config" command
switchport shows the detailed switchport configuration
commands in before the switchport mode. This caused
running-config problems with some scripts.
changed
Release 4.2.0.4
Summary User Impact
PowerConnect sFlow implementation is not per
sFlow specification
implementation
is not per
specification
Using config Doesn't affect any iscsi traffic. Constant log
wizard to setup messages with the error "Can't create static
8024 causes rule".
iscsi error
messages off
out-of-band in
console
8024 stack does If a user logs in via console - motd and
not follow login banners are executed
similar banner If a user logs in via ssh - only exec banner
execution for is executed
console, telnet If a user logs in via telnet - all 3 banners are
and ssh executed
Simple Switch FC not functional
should have FC
enabled by
default
OSPF error With 128 IPv4 & IPv6 interfaces & OSFP
message after configured a reboot caused the following
reboot error messages to be generated:
Failed to send message to OSPF mapping
thread in
ospfMapRoutingEventChangeCallBack()
These lost events could lead to incorrect
routing.
System Firmware Version 5.1.0.1
Corrected by not ignoring the
dropped VLAN frames in the
Discards counter
Corrected by adding a property
to bypass the lane initialization
when media-type preferences
is set.
Corrected the order of running-
configuration output.
Resolution
Issues corrected and passes
conformance test
Issue is corrected.
Behavior is now as follows:
Add motd banner display for
telnet connection before motd
acknowledge question is
asked.
Remove motd banner after
motd acknowledge question.
FC is enabled by default in
simple switch mode.
Issue has been corrected.
All 4.2 supported
platforms
PC70xx
All 4.2 supported
platforms
Affected Platforms
All 4.2 supported
platforms
PC8024
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
Page 33