Dell Networking 7048 Release Note page 26

"show spanning- The user may think that there is traffic over
tree detail" interfaces that are supposed to be inactive as
counters are far as spanning tree is concerned.
non-zero for
inactive
interfaces
Unable to The user may not be able to remove the
remove 0.0.0.0 default gateway for the OOB interface
as default causing unwanted traffic to go over the
OOB interface.
gateway on
OOB interface
using the web.
When The user may log in without having
acknowledged the MOTD.
connecting via
SSH, the user is
not prompted to
acknowledge the
MOTD
"encapsulation" The user could only set VLAN
command is encapsulation on a single VLAN at a time.
unavailable in
interface range
mode
M8024-k The user could not get accurate information
OpenManage about a stack of M8024-k switches from the
Web UI stack stack view web page.
view display
"spanning-tree The user could not see the configuration of
transmit hold- the hold-count parameter.
count"
command's
value is not
reflected in
show command
Inconsistent The user may be able to configure an
behavior in invalid spanning tree port priority in range
single and range mode.
interface mode
of "spanning-
tree port
CLI command The user could not reset the excluded
"no passwords keywords to the factory default of no
strength excluded keywords with a single command.
exclude- It was necessary to remove each excluded
keyword" keyword one at a time.
requires
<keyword>
Inline help for The help text might lead the user to think
"spanning-tree the command only applied to a single port
instead of all ports.
loopguard" is
incorrect.
Some of the Some of the options of "show ip pim"
options of "show command are not available in user EXEC
mode.
ip pim"
command are
not available in
user EXEC
mode.
24
Corrected the counters.
Added support for setting the
gateway to 0.0.0.0.
Add functionality to send the
acknowledge question when
new SSH connection is
created, but after
authentication.
Added support for the
encapsulation command in
interface range VLAN mode.
Corrected the information
displayed on the stack view
web page.
Corrected the output of the
"show spanning-tree detail"
command to include the
configuration of the hold-count
parameter.
Corrected the error handling so
that the invalid priority is not
used.
Correctly implemented the
"no" form of the "passwords
strength exclude-keyword"
command.
Corrected the help text so that
it indicates that the command
applies to all ports.
Added missing options to the
CLI tree.
System Firmware Version 5.1.0.1
All 4.2 supported
platforms
All 4.2 platforms that
support the OOB interface
All 4.2 supported
platforms
All 4.2 supported
platforms
PCM8024-k
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms