Dell Networking 7048 Release Note page 40

PC6220M GUI The issue using CLI stack ports shows up
shows stack- and counters shows no transfer rate but GUI
ports down but shows stack ports down.
CLI does not. In
previous version
issue didn't exist
M6220 - Customer has multiple M6220 switches,
Routing fails on and as part of a network change they
VLAN wanted to remove a VLAN routing interface
that was no longer in use. When they
removed the IP address from this VLAN,
they lost routing across the entire switch.
MIB walk SNMP MIB walk crashes switch.
crashes switch
M8024 - No On the web GUI-->system-->management
password min security-->password management,
length error
using web GUI If the password min length is unchecked
and applied, there is an entry in the running
config for "no passwords min-length". This
can be verified through CLI. After this, on
enable passwords page if we try to set a
password which is any length less than 8,
we get an error message as shown in the
attachment.
Bug in Simple Once you select the Tagged-Vlans, there is
Switch GUI. NO way to unselect them again via GUI.
Using command-line configuration is the
only way to unselect those.
M6348 simple Can't remove what running config says is
mode issue with there
10G ports in
aggregator
group
Banner motd The "banner motd" configuration changes
configuration after a switch reload.
changes after
reload.
Error message Attempting to assign an ACL to VLAN 1,
via Web UI via Web UI, generates an error message
refers to referring to the Management VLAN.
"Management "Error! Cannot Bind ACLs to Management
VLAN" VLAN."
Web UI not Binding an IP ACL as out bound to an
generating error interface, via Web UI, does not generate an
for out bound error message. Furthermore, the config
ACL & applies gets applied to the interface as an inbound
the config. ACL. When the same action is done via
CLI, an error message is generated and the
config is not applied.
38
Web shows stack ports up if
they are up
Ports are now checked to
ensure they are not part of
other routing VLANs before
clearing the ARP policy on the
port.
A large array is allocated
statically instead of on the
stack.
Password ranges are now
allocated dynamically on web
pages.
Tagged VLANs can be
unchecked in simple mode
Add interface command is
corrected.
Previously, the input
mechanism ignored ANY lines
beginning with an exclamation
point. Now, the CLI engine
will allow lines with a leading
"!" in the banner
the hard coded value has been
removed in favor of the correct
VLAN value
Use of the direction object has
been corrected.
System Firmware Version 5.1.0.1
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms