Dell Networking 7048 Release Note page 51

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
Summary
LLDP-Med TLV information
not registered for jumbo frame
sizes greater than 8000
VLAN binding entries are not
being displayed on Read-Only
mode user web page.
Unable to execute the
command dot1x timeout tx-
period 1
In switching> network security
>dot1x authentication web
page in read-only user mode,
the Re-Authenticate Now
check box can be checked
System Device information
web page LED information not
in sync with front panel LED
information.
DHCP snooping static binding
thru DHCP request is denied as
this is an expected behavior.
Mode of transfer is displaying
"unknown," while
downloading the code from ftp
Allow disabling and enabling
of terminal paging
Web does not allow to
configure image descriptor to
its max length i.e. 255
characters.
CDP (ISDP) is active on port-
channels instead of the member
Ethernet interfaces. For
dynamic LAGS, the ISDP
information is not exchanged
on the interface until the port-
channel becomes active.
CLI Manual Has No Index
System Firmware Version 5.1.0.1
User Impact
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations. Possible security issue.
No Potential operator impact expected.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations.
Potential operator frustration over switch
configuration.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations. Inability to interoperate with
other switches.
Potential operator frustration over switch
configuration.
Resolution
Jumbo LLDP frames are
now processed properly
VLAN binding entries are
available to read only users
This command is accepted
with a timeout period of 1
second. Corrected range
check on input.
Read-only properties are set
for the check box
This issue was regarding
various stylistic aspects of
the system device web page.
The system device web page
conforms to the requirements
as it exists and does
necessarily match the CLI
with regarding to
capitalization or naming
conventions
Removed the log message
indicating that a bound
DHCP client with an existing
binding sent a DISCOVER.
Added a counter for this
condition to the DHCP
debug statistics.
ftp transfer mode is
displayed
The terminal length
command is now
implemented.
Images descriptors up to
255 characters are allowed
CDP is active on the
member ports for dynamic
LAGs when the LAG is
active.
The CLI manual has an
index.
Affected
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
Page 49