Dell Networking 7048 Release Note page 50

Summary
Traffic is forwarding when
IPv6 forwarding is disabled
A LAG member comes UP if
configured individually as no
shutdown, even though the
port-channel's state is down
Re-authenticate Now check
box is not highlighted when
edit check box is selected
Block command is not seen in
show running config through
web and cli
FDB entries are getting aged
out before default age-out time,
when both FDB and MFDB
tables are full.
DHCP packets forwarding is
not proper to/from the trusted
and un-trusted ports
Configuring all ports in all
VLANs takes a long time
Max number of OSPF
neighbors not supported
Cable fault distance not getting
displayed in WEB in case of
cable with one or more pairs
cut or short.
Ports representation need to be
changed in debug messages
No error message for illegal
characters in various command
parameters
The ARP entry is not seen in
the ARP table when an ARP
reply is sent to DUT.
Mapping Table configuration is
not being displayed on Read-
Only mode user web page.
ACL is getting deleted when
trying to create max+1 rule.
48
User Impact
Incorrect operational state in network.
Incorrect operational state in network.
Inability to configure switch.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations.
Incorrect operational state in network.
Potential operator frustration with switch
management.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations.
Potential operator confusion over switch
operations. Inability to diagnose network
issues.
Potential operator confusion over switch
configuration.
Potential operator confusion over switch
operations. Inability to diagnose network
issues.
Potential operator confusion over switch
configuration.
Potential operator confusion over switch
operations. Possible security issues.
Resolution
The ipv6 forwarding
command is deprecated. To
disable traffic forwarding, use
the "no ipv6 unicast-routing"
in place of the "no ipv6
forwarding" command.
LAG members are placed in
the blocking state for
dynamic LAGs and only
come up when the LAG link
comes up.
The Re-authenticate Now
check box is highlighted
when the edit check box is
selected
The block command is a
temporary administrative
assignment and is not
maintained persistently in
the saved or running configs.
On the PCM6220, the
MFDB and FDB tables are a
shared resource. The user is
continually sending new
MFDB entries, which causes
old FDB entries to be
removed to make a place for
the new MFDB entries.
The frame flooding routing
in DHCP snooping now
takes into account trust
status.
VLAN configuration has
been optimized.
The maximum number of
neighbors is supported.
The fault distance is
displayed in the web page.
Ports are now displayed in
C/S/P standard format
The accepted character set
and length is documented in
the CLI reference manual.
ARP entries are stored
properly
The mapping table is
displayed for a read-only
user.
Corrected error checking
logic.
System Firmware Version 5.1.0.1
Affected
Platforms
PCM8024
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms