Dell Networking 7048 Release Note page 25

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
VLAN ACL ACL prevented traffic from reaching
blocks traffic destination
across stack
members
Power supply Power Supply messages are only sent to the
logging log file.
'no ipv4 or ipv6 'no ipv4 or ipv6 address found in response
address found in for request id' error message flooding the
switch
response for
request id' error
phone port The phone port is missing some needed
commands
configuration
macro
incomplete
web session Web session would timeout regardless of
timeout the timeout setting
RX Equalizer RX Equalizer was not set on the stacking
setting on port which caused stacking errors to be
Stacking ports. reported.
interface speed Invalid speed options message is not clear
options
Change PoE PoE controller Disconnect Type was
Disconnect changed to DC Disconnect.
Type to DC
disconnect
stacking with Stacking with redundant stack rings caused
extension packet flooding on the stacking links.
modules
DHCP Req pkts When using Avaya phone on a switch
are not being running dot1x, the phone will NOT get
forwarded to authenticated and thus will not boot
Voice VLAN
Component
Netlogic Netlogic memory and B0 CPU support
memory and B0
CPU support
Release 5.0.0.4
Summary User Impact
OpenManage UI Port description does not accept space
does not accept
blank space
character for
port description
System Firmware Version 5.1.0.1
Prevented VLAN ACL from
being applied to stack ports.
Elevated failure messages to
ERROR severity
Corrected problem that was
causing extra error messages to
be displayed.
Added missing commands to
the pone port macro.
Corrected the hard timeout to
be one hour.
Added RX Equalizer value.
Changed the message reported
when an invalid speed option
is input.
PoE controller Disconnect
Type was changed to DC
Disconnect.
Corrected problem with stack
link queuing.
Corrected DHCP forwarding
problem.
Added support for Netlogic
memory and B0 CPU.
Resolution
Correction the port description
validation to accept spaces.
All 5.0 supported
platforms
All 5.0 supported
platforms
All 5.0 supported
platforms
All 5.0 supported
platforms
All 5.0 supported
platforms
All PC70XX Switches
All 5.0 supported
platforms
PC7024P
PC7048P
All 5.0 supported
platforms
All 5.0 supported
platforms
PC8132
PC8132F
PC8164
PC8164F
Affected Platforms
All 4.2 supported
platforms
Page 23