Troubleshooting - Yamaha DV-SL100 Owner's Manual

Troubleshootin8
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not
listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power
cord, and contact the nearest authorized YAMAHA dealer or service center.
Problem Solution
No power Check if the AC power" cord is pr_)pedy connected.
No picture Check if the TV is switched on.
Check the video connection.
If you did not use Pr_)gressiveScan connections (usingthe Y PBPRjacks on the
DVD Player'} and you do not have a picture at the TV, please follow the steps
below to tum off Progressive Scan;
1. Press _A (OPEN/CLOSE) to open the disc troy.
2. Press 4.
3. Then press NUTE to deactivate the Pr_)gressive.The DVD Player will reset
itself to Component/interlaced video. The disc tray will closed automatically
to let you know it has reset itselfi
The disc is badly scratched or"dirty.
Sometimes a small amount of picture distortion may appear.
This is not a malfunction.
Hake sure the NTSC/PAL setting at the DVD player matches the video signal
of your television. (See NTSC/PAL CONVERSION)
Distorted picture
Completely distorted picture or
blacldwhite picture with DVD or
Video CD
No sound or distorted sound Adjust the volume.
Check that the speakers are connected correctly.
No audio at digital output Check the digital connections.
Check if your receiver can decode DTS or NPEG-2 and if not, please make sure
the digital output is set to PCN.
Check if the audio format of the selected audio language matches your receiver"
capabilities.
Disc can't be played The DVD+R/DVD+RW/DVD-R/DVD-RW/CD-R/CD-RW must be finalized.
Ensure the disc label is facing up.
Check if the disc is defective by trying another disc.
If you have recorded this particularjPEG CD or" NP3 CD yourself, please
ensure that your disc contains at bast about 6-10 pictures or" 3-Sjvlp3 music
tracks before using it with the player.
No return to start-up screen when Reset the unit by switching the player"off] then on again.
disc is removed
The player does not respond to the Aim the remote contr'ol directly at the sensor on the frx_nt of the player_
remote control Reduce the distance to the player.
RepBce the batteries in the remote contr_k
Insert the batteries with their" polarities (+_ signs) as indicated.
Buttons do not work In order to completely reset the player, unplug the AC cord from the AC
outlet.
Player does not respond to some Operations may not be perTTlitted by the disc. Refer"to the instructions of the
operating commands during disc.
playback
22