Inserting Batteries Into The Remote Conu'ol; Using The Remote Control; Ntsc/Pal Conversion; Turning On The Power - Yamaha DV-SL100 Owner's Manual

Preparation
Inserting batteries into the Remote
Control
1 Open the battery cover" by pressing in the tab, then [fit off
the cover.
2 Insert batteries with the correct polarity as indicated by
the -F and -- symbols inside the battery compartment.
3 Close the cover.
NTSC/PAL Conversion /
This player is equipped with a NTSC/PAL conversion
feature to convert the video output of the disc to match
your TV system. The conversions supported are as
below. To activate the conversion, refer to "TV TYPE":
NTSC NTSC PAL NTSC
DVD
PAL NTSC PAL PAL
NTSC NTSC PAL NTSC
VCD
PAL NTSC PAL PAL
CAUTION!
- Remove batteries if they ore exhausted or not to
be used for a long time.
- Do not use old and new or different types of
batteries in combination.
- Batteries contain chemical substances, so they
should be disposed off properly and kept away
from children.
Using the Remote Control
• Direct the remote control at the remote sensor of the
DVD player'.
• Do not drop or give the remote control a shock.
• Do not leave the remote control in extremely hot or
humid places.
• Do not spill water" or put anything wet on the remote
control.
Notes:
- "'MULTI" can only be selected when using a TV that has
both the NTSC and PAL systems.
- Slight picture distortions may occur due ta this conversion.
This is normal. Thus, the "'MULTI" is most suitable far the
best picture quality.
Turning on the power
1 Connect the AC power cord to the power" outlet.
2 Turn on the TV and your AV receiver.
3 Select the appropriate input source at the AV receiver
that was used to connect to this unit. Refer to the
equipment owner's manual for detail.
4 Turn this unit on.
5 Set the TV to the correct Video IN channel. (eg. EXTI,
EXTZ AV1, AVZ AUDIO/VIDEO, etc. (Refer'to your TV
owner's manual for" detail)
The front display lights up and the default screen
appears on the TV.
Smart Power On/Off
When in STOP or NO DISC mode,the DVD player will
switch to standby mode after"15 minutes without any
operations for savingenergy. It is easily reactivated by
pressingthe POWER or PLAYon the remote control or
the STANDBY/ON bcrtton on the front panel.