Additional Information; Troubleshooting; General; Remote Control - Yamaha CinemaStation DVD-S30 Owner's Manual

Hide thumbs Also See for CinemaStation DVD-S30:
Table of Contents

Advertisement

ADDITIONAL INFORMATION

Troubleshooting

If there is any problem with your system, check the following items. If you cannot solve your problem with the following
remedies or if your problem is not listed below, turn off and unplug the unit, then consult the nearest authorized
YAMAHA dealer or service center.

■ General

Problem
Power turns on but immediately
shuts off
The speakers make no sound
The TV shows no picture
This unit suddenly turns off

■ Remote control

Problem
The remote control does not
work for operating this unit
Downloaded From Disc-Player.com Yamaha Manuals
24
ADDITIONAL INFORMATION
The power cable may be connected
improperly.
This unit may receive a strong electrical
shock such as from a lightening bolt or
excessive static electricity.
The cables may be connected improperly.
The disc loaded into this unit may be not
compatible.
A DTS source is played back using an analog
output jack.
A DTS source is played back while "PCM
ONLY" is selected for "DIGITAL
OUTPUT" in the Setup menu.
The cables may be connected improperly.
The Sleep feature (page 22) might be set.
The remote control may be operated
outside the remote control operation
range.
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The batteries may be worn out.
Cause
Make sure the power cable is plugged into the
outlet firmly.
Set this unit to the Standby mode, then
disconnect the power cable. Wait for about
30 seconds, then connect the power cable
and turn on this unit.
Make sure all cables are connected properly.
(
page 6
Make sure you use a disc supported by this
unit. (
Use a digital connection to play back a DTS
source.
Select "ALL" for "DIGITAL OUTPUT" in
the Setup menu. (
Make sure all cables are connected properly.
(
page 6
Turn on this unit and play the source again.
Cause
For information on the remote control
operation range, refer to "Using the Remote
Control" (
Change the lighting or this unit's orientation.
Replace the batteries with new ones. (
Solution
)
page iii
)
page 22
)
)
Solution
).
page 7
page 7
)

Advertisement

Table of Contents
loading

Table of Contents