ProScan PS35682 Owner's Manual page 83

Noisy stereo reception
• Maybe a weak station. Set the Mode: stereo/mono function in
the STEREO S ETUP m enu to Mode: mono. Details are on page 28.
No picture, no sound but power light is on
• Wrong antenna input (a or e) selected. Try pressing ANT
(antenna) button on master remote. Details are on page 41.
•
Cable/air function on SETUP menu has been accidentally
changed, Details are on page 40.
• Maybe a vacant channel is tuned.
• For channels 91 and 92, make sure the component connected
to those INPUT jacks is turned on.
• If watching VCR (connected only through antenna input),
make sure TV is tuned to channel 3 or 4 - same as CH3/CH4
switch on VCR. Also check to make sure rvNca switch on
VCR is in correct position.
Sound okay, picture poor
• Check antenna connections.
• Try adjusting SHARPNESS function to improve weak signals.
• If recording one channel on VCR connected to ANTinput and
watching another channel on the TV, make sure the VCR's
rVNCRswitch is in correct position (VCRindicator turned off).
No picture while using picture-in-picture with VCR, laser
disc player, or camcorder.
• If using an S-VHS component, make sure its regular video
cable is also connected to the INPUT jack on the TV. S-VHS
video can not be viewed on the small picture.
• If using the VCR1 or Yea2 button, make sure it is programmed to
select the proper channel as described on page 43.
No audio while using picture-in-picture with VCR, laser disc
player, or cameorder.
• Be sure to connect audio cables in addition to S-VHS cable.
The S-VHS cable carries only video, no audio.
TV shuts off and then comes right back on
, Power interruption may have occurred.
• Automatic shutdown circuit may have been triggered as
described on page 4.