The ProScan master remote that came packed with your
TV also controls most brands of VCR's and cable-TV
boxes. The buttons shown below can be used to operate
:our TV. The rest of the buttons are used to control VCR's,
LaserDisc players, audio equipment, or cable boxes and are
explained on pages 53-57 and 64.
For added convenience,
the simplified six-button remote
also lets you control most of the TV's operations and
functions using the advanced menu system.
@
®
@
@
@
@
@
@
®
®
®
@
_)
TV Button
TV and
remote in "TV Mode" so
turns
on
puts
that the other remote buttons will control the TV. Also
@
displays
time (if clock
has been set) and channel
number
on
the TV screen.
Important
Note:
Most buttons
on the master remote control will
not control the TV unless the remote is in the "TV Mode".
If
another component
button (such as VCR1, VCB2, CABLE, or AUDIO)is
pressed, the remote will no longer be in the "TV Mode".
To get
back into the "TV Mode", simply press the button labeled TV. The
remote will go back into the "TV Mode" and will control the TV
again.
CHANNEL Buttons
Press CHANNEL up tO see the next higher channel in memory,
or press CHANNEL down to see the next lower channel in
memory.
Your TV will automatically
program active channels for
your area into memory when you start the AutoProgram
feature described
on page 46. You can also add or remove
individual channels from memory as described
on page 47.
®
®
VOLUME Buttons
Press
VOLUME
up to increase volume, or press
VOLUME
down
to decrease
volume. The volume display will automatically
appear on the screen when you press the VOLUMEbuttons.
®
MUTE Button
Press MUTE
tO
quickly reduce sound to its minimum level
without affecting the picture.
This is very useful during
telephone
calls or other interruptions.
When sound is muted,
the word Mute will appear on the screen for a few seconds to
let you know you have muted the TV. To restore sound,
press MUTEagain or press VOLUME up.
PC (Previous Channel) Button
Pressing the PCbutton causes the TV to change back to the
last-tuned
channel.
This is useful should you want to
monitor two channels.
To operate, select the first channel you want to watch. Then
select the other channel by pressing two number buttons.
The TV will now change back and forth between the two
channels each time you press the PC button.
Need help?
Do you have a question about the PS35682 and is the answer not in the manual?