ProScan PS35682 Owner's Manual page 12

Operating Remote Controls
Before attempting to operate either one of the remote
:ontrols, install the batteries as shown below.
Installing]Replacing Batteries
1 Turn each remote control face down.
2 Press down on the ridged area of each battery cover and slide
it off.
Using the Remote Controls
Aim either remote control at your TV's remote control
sensor. The remote controls produce an invisible
(infrared) beam that travels in a straight line much as the
beam of a flashlight. For this reason, when operating
either one of the remote controls, you must point it
directly at the front of the TV without objects between that
can block the infrared light beam.
3 Install the "AAA" batteries in each compartment as shown.
4 Replace the covers and turn remotes over (face up).
Notes: Replace the batteries when the TV fails to respond to the remote
conlrol.
If you programmed your master remote to control other components, you
may have to reprogram the code numbers when you change batteries.
Try not to press any buttons while changing batteries.
Never place anything heavy on top of the remote control or lay it upside-
down. This may accidentally depress the buttons for a long time and
discharge the batteries.
Do not mix new and used batteries or different brands of batteries.
If battery leakage occurs, wipe up the liquid inside the compartment and
replace the batteries with new ones.
Aim remote at yourTV's remotecontrol sensor.
6__