ProScan PS35310 Owner's Manual page 6

rst_Time 0p
The steps below will help you get your TV connected and
working quickly. The page numbers on which you can find
detailed instructions for each of these steps are also listed
for your convenience.
1 Unpack TVand accessories.
The accessories that came packed with your TV include
two remote controls, six AAA batteries, power cord, and
antenna adapter.
2 ImportantInformation:OptionalStand
A matching stand has been designed to be used with this
TV receiver. The recommended stand, Model RB2710, is
provided with hardware to secure the TV to the stand so
that it cannot be pulled off easily or tipped over.
This stand is available from your local PROSCAN dealer.
This item is not available by mail order. To locate your
nearest PROSCAN dealer, call this toll-free number: 1-800-
PROSCAN.
Caution: If you choose not to use the recommended stand
for your TV receiver, take precautions that the stand or
other furniture on which the TV is placed is properly
located and of adequate strength to prevent the TV from
being tipped over accidently or pulled off the stand.
Tipping the TV over or pulling it off the stand could cause
both damage to the set and personal injury.
3. Connectantenna or cable-TV system.
/_ i ANTA
ill:I! @
_r(irll Arltenrl_ 01
CaUle-]VSystem @
@
CONVErtER
Attach power cord.
First attach the flat end of the power cord completely into
the connector on the back of your TV, and then plug the
other end into a wall outlet.
Be sure to insert the plug completely.
Back ofTV _,
%
DoThis Not This
5 Install batteries in remote control.
Details are on page 4.
6 Turnon TV, adjust the volume, and select a channel.
TV Button
-J CHANNELBt
VOLUMEButtons
-- NumberButtons
To turn oll the TV, press the Tv
button on the master remote or press the POWER b uttol]
on the simple remote. When using either remote,
remember to point it at the front of the TV.
Press the VOLUME u p or down button to adjust the
volume to a desired level.
Press the
CHANNEL
up or down button to select the next
channel in memory. You can also press two number
buttons to select a channel. Channels 2-13 and 91 were
programmed into the channel memory at the factory, so
pressing CHANNEL up or down stops at these channels
only. When you start the autoprogramming feature
(described next), your set will automatically scan
through all channels and place the active channels for
your area into its channel memory.
Most antenna or cable-TV systems can be connected as
shown here.
• Details for connecting a home antenna to your TV are on
page 36.
• Details for connecting a cable-TV system to your TV are
on pages 37-39.
• Details for connecting a VCR toyour TVare on
pages 41-42.