Netcommand® Initial Setup - Mitsubishi Electric WD-52527 Owner's Manual

NetCommand ® lnitiam Setup
IMPORTANT
When you first power On your new Mitsubishi TV, the
initiaHsetup screens appear. The process allow you
to quicMy set up NetCommand and the TV Guide On
Screen@ system. Most IR remote controH signaH formats
can be Hearned by NetCommand.
NetOommand (information} Screen
Figure 2
The NetCommand (Information) Screen describes how
to start or delay the initial NetCommand and TV Guide
On Screen setup. This screen displays automatically
the first time you power On your new TV, after the
Welcome screen.
WeJcome Screen
Figure 1
When you first turn on your TV, the NetCommand
Welcome screen displays and asks you to select either
English or Spanish as the language for the on-screen
menus. The default language is English. To change
Language later, select Setup in the Main Menu. Selecting
Cancel at this screen will cause the default language
(English) to be selected.
Figure 2. Information screen
Select Next> and press ENTER to start the initial setup.
Figure 1, Welcome screen
If the NetCommand Setup is cancelled before it's
completed, you can restart the NetCommand setup by
1. A press of TV MENU on the remote control to display
the TV Main menu.
2. Select NetCommand. The available options will be:
Add, Review, Guide or Initial. Change and Delete will
be grayed out.
3. Press ADJUST _., V, ,_ or _ to select Initial.
4. Press ENTER. The Device Setup screen (shown on
the next page) displays.
40 Chapter 3. NetCommand Setup and Editing