Mitsubishi Electric WD-52527 Owner's Manual page 91

Appendix C: Remote Controm
Programming Codes, continued
IMPORTANT
Some manufacturers may change their
products, or they may use more than one
remote control system, mf t his is the case,
your remote control may not be able to
operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
After entering the correct codes in each position of the
remote controH, use the sHide switch to seHect which
product will respond when an operafionaH button is
pressed. OnHy one of the bellow devices is allowed for
each sHideswitch position.
TV position:
[] TV, NetCommand® Controlled Devices
Cable/DBSiDTV position:
[] Cable box
[] Satellite receiver
_J DTV receiver
VCR position:
[] VCR
DVD position:
[] DVD
_1 LD Player
Audio position:
[] AiV receiver
[] Mitsubishi CD player
If you have a Mitsubishi AiV receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
010.
When your remote control has been programmed to
operate another manufacturer's product, the function
performed on each layer can vary. The most common
functions are:
VCR
POWER
CHANNEL up/down
PLAY
REC
PAUSE
STOP
FF/FWD
REWiREV
Mitsubishi VCRs wiii be compatible with some
additional buttons
Cable Boxes and Satellite Receivers
POWER
CHANNEL up/down
0-9 number buttons (on some models)
ENTER (on some models)
CANCEL (on some models)
ADJUST up/down/left/right (on some models)
GUIDE (on some models)
A/V Receivers
POWER
VOLUME
MUTE
Mitsubishi A/V Receivers
Direct Input Selection buttons:
Numbers, SQV and QV (on some models)
Mitsubishi CD Players
(not all functions for all models}
PLAY
FF/FWD
REW/REV
PAUSE
STOP
DVD Players
(not all functions for all models)
POWER
MENU
0-9 number buttons (on some models)
PLAY
STOP
ARROW up/down/left/right (on some models)
FFiFWD
REWiREV
PAUSE
CANCEL (on some models)
ENTER
CHANNEL (on some models)
Chapter 6. Special Features
91