Edit Netcommand® Add An A/V Receiver - Mitsubishi Electric WD-52527 Owner's Manual

Edit NetCommand®, Add an A!V Receiver
A/V Receiver Screen
Figure 7
If your A/V Receiver manufacturer was not iisted, and you
sebcted "None" during the initiai NetCommand setup,
you may add the AiV Receiver and have NetCommand
barn its remote controFs functions. Either sebct Edit
from the Finish screen or, if you have finished the initiai
setup, go to the Main menu, sebct NetCommand, then
press ENTER. The Edit NetCommand screen will dispiay.
Sebct Add.
Figure 7. A/V receiver screen
Sebct "Other," skip Learn and sebct Next>. This
will allow the device to appear and will allow
NetCommand to switch inputs to use this devbe.
However, NetCommand will not be aMe to control
this device. Later you may use the "Change" option
in the NetCommand menu to learn the remote control
signals.
After selecting Next>, the screens that follow are: the
AiV Receiver Input screen (Figure 8), Name screen
(Figure 11), Audio Out to AVR screen (Figure 12),
ending with the Finish screen (Figure 13)_
Choose ONE of these options:
Select a recognized manufacturer. The model number
optimized for NetCommand will display at the bottom
of the screen. If a number follows the manufacturer's
name, (example: Mitsubishi 1), this indicates additional
models are optimized for that manufacturer. For many
device types, non-listed models will operate in the
same way as the listed models and you can still use
the preqoaded setting.
After selecting Next>, the screens that follow are: the
Name Screen (Figure 11), Audio Out to AVR screen
(Figure 12), ending with the Finish screen (Figure 13)_
Select "Other", then highlight "Learn" and press
ENTER. This will allow you to have NetCommand
learn the remote control signals of this new device.
After selecting "Learn" and pressing ENTER, the
screens that follow are: the AiV receiver Inputs screen
(Figure 8), A/V Receiver Input Learn screen (Figure 9),
AiV Receiver Learn screen (Figure 10), Name screen
(Figure 11), Audio Out to AVR screen (Figure 12),
ending with the Finish screen (Figure 13)_
A/V Receiver inputs
Figure 8
If you select "Other" as the manufacturer and then
"Learn," you will see the AiV Receiver Input screen.
After selecting the number of inputs, this screen will not
appear again.
Depending on your AiV Receiver's capability, you may
connect up to seven (7) AiV inputs. Select the number
of inputs by pressing ADJUST A. or V'.
If the number of connected inputs changes, you wiii need
to delete the A/V receiver through Edit NetCommand and
add it again, as described above,
Figure 8. A/V receiver input screen
Chapter 3. NetCemmand Setup and Editing 43