Mitsubishi Electric WD-52527 Owner's Manual page 44

Edit NetCommand ®, Add an AiV Receiver, continued
A/V Receiver (AVR) Input Learn Screen
Figure 9
NetCommand can now barn the remote controi signab
used to sebct each input on the AiV receiver+
1. Press ADJUST _ or _ on the TV remote to sebct the
check box for each function to be bamed.
2. Press ENTER and the function name wiii begin to flash
to confirm the ready-to-learn status+
3. Press the button on the A/V receiver's remote control
that corresponds to the selected function+ A check
mark wiii appear and the function name wiii stop
flashing+ This confirms the signal learned status+
4. To test the learned command, press ENTER on the TV
remote+ The AiV receiver will perform the selected
function. The AiV receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
5. To customize the input names, press ADJUST _ to
move to the Input Name text box and then press
ADJUST A or V and ENTER to select each letter of
the name+ These names will appear on the Review
screen as the AiV receiver's input names, and should
match the names the AiV receiver shows in its own
display.
6. To erase the learned input signal, highlight the check
box for that input and press CANCEL+
7. Repeat for each connected input+
8. When the input selection signals have been learned
and the inputs named, press ADJUST _ to select
Next> and move to the A/V receiver Learn screen+
Figure 9. A/Yreceiver Input Learn screen
A/V Receiver (AVR) Learn Screen
Figure 10
1. Press ADJUST _ or _ on the TV remote to select the
check box for each function to be learned.
2. Press ENTER and the function name wiii begin to flash
to confirm the ready-to-learn status+
3. Press the button on the A/V receiver's remote control
that corresponds to the selected function, A check
mark wiii appear and the function name wiii stop
flashing+ This confirms the signal learned status+
+
To test the learned command, press ENTER on the TV
remote+ The AiV receiver will perform the selected
function. The AiV receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 31 for IR emitter placement).
5+ Repeat for each function to be learned.
6+ To erase a learned function, highlight the check box for
that function and press CANCEL+
7. When the function signals have been learned, press
ADJUST _ to select Next> and move to the Name
screen.
Figure 10. A/V receiver Learn screen
Chapter 3. NetCommand Setup and Editing