Netcommand® Initial Setup - Mitsubishi Electric WD-73727 Owner's Manual

NetCommand® initial Setup
The initiaH setup screens that appear when you first power
on your new Mitsubishi TV guide you through setup of
NetCommand and the TV Guide On Screen@ system.
Most JR remote controH signaHformats can be Hearned by
NetCommand.
WeJcome Screen
Figure 1
When you first turn on your TV, the NetCommand
WeHcome screen dispHays and asks you to seHect either
EngHish or Spanish as the Hanguage for the on-screen
menus. The defauHt Hanguage is EngHish. To change
Language Hater,seHect Setup in the Main Menu. SeHecting
Cancel at this screen will cause the defauHt Hanguage
(EngHish)to be seHected.
Figure I. Welcome screen
NetOommand (information} Screen
Figure 2
The NetCommand (information) Screen describes how
to start or delay the initial NetCommand and TV Guide
On Screen setup. This screen displays automatically the
first time you power On your new TV, after the Welcome
screen.
Figure 2. Information screen
Select Next> and press ENTER to start the initial
setup.
If the NetCommand Setup is cancelled before it's
completed, you can restart the NetCommand setup
from the Setup Reminder screen (see below) or by
doing the following:
1. Press TV MENU on the remote control to display
the TV Main menu.
2. Select NetCommand. The available options will be
Add, Review, Guide or Initial. Change and Delete
will be grayed out.
3. Press ADJUST A T _ _ to select initial.
4. Press ENTER. The Device Setup screen (shown
on the next page) displays.
Setup Reminder
Figure 3
This screen only appears if you did not set up
NetCommand when the TV was first turned on. The
Setup Reminder screen displays for the next six times
you power on the TV.
If you would like to set up NetCommand and/or the
TV Guide On Screen system, select Next and press
ENTER. If you do not wish to set up NetCommand
and/or the TV Guide On Screen system, then select
Cancel and press ENTER.
Figure 3. Setup Reminder screen
IMPORTANT
You use your TV without setting up
or the TV Guide On Screen@
system. To set up at a Jater time, choose the
NetOommand menu from the Main menu,
then seJect hitiaL The TV Guide On Screen
system is set up from the NetCommand
menu,
42 Chapter 3. NetCemmand Setup and Editing