Wall Outlet Cable Or Cable Box - Mitsubishi Electric WD-52527 Owner's Manual

Connecting a Wail Outlet Cable or Cable Box
Wall OutJet CabJe
(can be used with a OableOARD
TM)
Figure 1
it is very important to connect the incoming cable for
your primary viewing source to ANT=l, especially for
CableOARD
TM
use.
1. Connect the primary incoming coaxiai Headcame to
ANT-1 MAiN on the TV back panel
2. For an optional secondary antenna source, connect an
antenna (or cable) to ANT-2 AUX.
3. If you have subscribed to a CableCARD
TM
service, the
CableCARD can now be inserted into the CableCARD
SLOT. Using a Phillips screwdriver, remove the
CableCARD cover screws. Insert the CableCARD,
then replace the cover and screws. Additional
CableCARD information is on page 20.
TV back panet section
{coiner rerno[_ed)
m
2. Optional Secondary
Antenna or Cable
Figure 1. Walt Outlet Cable
Standard CabJe Box
(analog cable box, other than an HDTV cabmebox,
compatibme with PIP/POP}
Figure 2
3 coaxial cables and one two-way RF spfitter are required,
These are not included with the T_Z
Note: See page 29 to connect an HDTV cable box.
1. Connect the incoming cable to IN on an RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to IN on the analog cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT-2 AUX on the TV back panel.
5_
After the cable box is connected to ANT-2 AUX
as shown, open NetCommand and go to the RF
Connection for Cable screen and do the following:
a. Check the RF check box.
b. For antenna, select ANT-Z
c. For Channel, select the channel to which the
TV must be tuned for your cable box. The
default channel is 3.
When this setup is complete, you can use the TV remote
control to change channels on the cable box.
L TV back panBI s[Sction
RF splitter
s-. r
! <--_ .......
CablE] Box
back panBI sBction
3=
4.
Figure 2, Connecting a Cable Box
Note: To use a cable box connected to ANT=2
as shown above, you must make the noted
NetCommand changes. The changes are
required to change the NetCommand cable=box
default connection (Component=l) to the actual
connection (ANT-2).
Chapter2. Connecting 23