Netcommand® Setup On-Screen Buttons - Mitsubishi Electric WD-52527 Owner's Manual

NetCommand® Setup OnoScreen Buttons
To use the TV's NetCommand feature, you need to provide some detaibd information during the setup of your
Mitsubishi TV. You must define the manufacturer of the devices that are connected to the tebvision, or barn the IR
code remote controi signais for the device connected. For each device, the input to the TV and AiV receiver, and the
names for the device are pre-set during Initiai NetCommand setup. You may change those inputs or names using the
Edit NetCommand or Learn screens. The buttons described bellow will heip you navigate the screens.
On your remote control, the ADJUST 4 or _ buttons allow
you to navigate left and right to different selections on the
screen. The ADJUST _ or _' buttons allow you to:
Change the radio button
o Change current text box selection
Navigate up and down on the screen
The ENTER button allows you to:
Confirm the selected character when naming a
device
Add or delete check marks in check boxes
Select on-screen buttons to change screens
Text Box
ControJ Buttons
Much Hikethe software on your computer, you will use
graphic buttons to navigate through the NetCommand
Setup screen. Highlight the button and press ENTER to
select the function.
<Back Button
Use the <Back button to navigate back to the previous
screen.
Next> Button
Press ADJUST A or Y to make a selection.
Check Box
Use the Next> button to navigate forward to the next
screen,
Cancel Button
Check marks indicate the item or input is added or turned
On. Press ENTER when the Check box is highlighted to
add or delete a check mark. When viewing the Review
screen, a Check box reflects which devices are turned
On or Off, or connected to the TV.
Radio Buttons
The Cancel button wiii cancel out any changes you
are currently making without saving them into memory.
When you select the Cancel key, NetCommand will
prompt you to confirm that you want to cancel the
changes you are currently making. If you select Cancel
during Initial Setup, you can setup NetCommand later by
selecting the NetCommand menu, then choosing Initial.
The setting changes when one of the choices is
38 Chapter 3. NetCemmand Setup and Editing