Antenna With Single Lead; Antennas With Separate Uhf And Vhf Leads - Mitsubishi Electric WD-52527 Owner's Manual

Connecting an Antenna with a Single Lead or Antennas with
Separate UHF and VHF Leads
Antenna with Single Lead
(not for use w{th CabmeCARD
TM}
Figure
3
A 300-Ohm to 75-Ohm transformeris required. This is not
included with the TV, but is available at most electronics stores.
For antennas with flat twin leads
1. For an antenna with flat twin leads, connect the
300-Ohm twin leads to the 300-Ohm to 75-Ohm
transformer.
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For cable or antenna with coaxial lead
3. Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
_0'O"rO"r'_"_ad--_ _ii:i'77°'1t_'_
I "_ TV back partial s[_ction
Optional 300-Ohm
to 75--©hm
Matching rransformNr
Figure 3. Connecting a Single Antenna
Antennas with Separate UHF and
VHF Leads
Figure 4
A UHF/VHF combiner is required, This is not included with
the TV.
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV
back panel.
VHF AntBrLna UHF AntBr_na
(Char_l_ls 2 13) (Char_nBIs 14 69)
Flat ]_vin LBad
Flat ]_vin L_ad
Exf_mal
or Cab_
TV back pan[_l s[_ction
i,
Figure 4. Connecting separate UHF and VHF Antennas
lVlitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Chapter 2. Connecting