Mitsubishi Electric WD-52527 Owner's Manual page 41

NetCommand ® initial Setup, continued
Device Setup Screen
Figure 3
If the devices connected to the TV are aiready in
NetCommand memory, you can qubMy sebct them
at this screen. Press ADJUST _ or _ to move to each
device type. Press ADJUST _ or _ to sebct the
manufacturer. Sebct "Other" if the manufacturer is not
iisted. Later, you can use the Change setting in the Edit
NetCommand menu to barn the remote controi signais
for this device. Sebct "None" for device types that are
not connected.
For the AiV Receiver, if the manufacturer is not
iisted, you cannot sebct "Other". Instead, sebct
"None". Later, you can use the "Add" feature in the
NetCommand menu to have the TV add and barn the
remote controi signab for this device.
If you have a camcorder connected, check the
Camcorder box. NetCommand will not be abb to
controi it, but will reserve the front input to use with
the camcorder. After completing your choices, select
Next> and press ENTER.
TV Guide On Screen® System Setup
Figure 4
The TV Guide On Screen option allows you to select
whether you want to enable the TV Guide On Screen
system and, if so, which devices you want to include. In
order to get the correct listings for your area, you will
need to enter your five-digit ZiP code.
You can select one over-the-air source and one cable
source for TV Guide On Screen. if, however, you have
multiple cable sources, the channePnumber assignments
may not match up correctly. See the table below for the
preferred connection combinations.
If One Source Is: The Other Source Can Be,
Ant-1 over-the-air , Cable box (on any input)
reception * Ant-2 channels memorized
via cable
Ant-2 over-the-air _ Cable box (on any input)
reception _ CableCARD
TM
on Ant-1
Ant-1 channels memorized
via cable
For detailed information on using the TV Guide On
Screen system, please see the separate TV Guide On
Screen Interactive Program Guide User's Manual
Figure 3. Device Setup screen
Note: If you selected "Other" for any of the
device names, you can direct the TV to "Learn"
the connected device by following the Edit
NetCommand instructions. For many device types,
non-listed models will operate in the same way as
the listed models and you can still use the pre-
loaded setting.
Figure 4, TV Guide On Screen
Note:
Inputs to TV Guide On Screen can include:
Only one over-the-air source
Only one cable source
If your cable box is connected using HDMI or
IEEE-1394, we recommend you also connect an
antenna.
If your cable box is connected to Component 1 or 2,
you should make sure the box is set to send analog
channels as 480k If this is not possible, add an
antenna.
Chapter 3. NetCommand Setup and Editing