Dvd Player With Component Video; Hdtv Cable Box Or Satellite Receiver With Component Video - Mitsubishi Electric WD-52527 Owner's Manual

Connecting a DVD Player with Component Video
Connecting an HDTV Cable Box or Satellite Receiver with
Component Video
DVD Player with Component Video
Figure 9
Component video cables and audio cables are required,
These are not included with the TV,
1. Connect the Component Video cables from _r;IPri
Pb VIDEO OUT on the back of the DVD player to
COMPONENT-2 on the TV back pane[, matching the
correct connection:
Y to Y (Green)
Pr to Pr (Red)
Pb to Pb (Blue)
2. Connect a set of audio cables from AUDIO OUT
on the back of the DVD player to COMPONENT-2
AUDIO Input on the TV back panel The red came
connects to the R (right) channel and the white came
connects to the L ([eft) channel
Figure 9. Connecting a DVD Player with Component
Video
Note: NetCommand@ wiil assume you
connected your DVD player to Component-2. If
you add a second DVD or use any other inputs
for your DVD, this change must match in the
NetCommand system. See Edit NetCommand...
in Chapter 3 for more information.
HDTV Cable Box or Satellite Receiver
with Component
Video
Figure 10
A coaxial splitter, RCA component video cables, and audio
cables are required, These are not included with the T_/:
1. Connect the outside antenna, cable, or satellite to
ANT or SATELUTE IN on the came box or satellite
receiver. See your device's owner's guide for
instructions and came compatibility.
2. Connect the incoming terrestrial antenna or cable (not
satellite) to ANT-1 on the TV back pane[ (a coaxial
splitter, available at most electronic supply stores,
may be required to complete this installation).
3. Connect RCA-type cables from the YPrPb outputs
on the DTV receiver to Component-1 on the TV back
pane[, matching the correct connections:
DTV Receiver to TV Back pane[
YtoY
, Pr to Pr
Pb to Pb
4. Connect L ([eft) and R (right) audio cables from the
DTV receiver to Component-1 AUDIO on the TV back
panel
5. If you are using a cable-box input other than
Component-1 (the ddau[t), open the NetCommand
RF Connection for CaMe screen (see page 49) or
the Connection for [device] screen (see page 48) to
change the input.
Note: To use the benefits of a digital A/V receiver,
connect your cable box or satellite receiver's digital audio
out to a digital input on your digital AiV receiver.
DI_ [1 ec ei_J_ {with yF_pb c onne_tio_)
2.
4-- _:_i _ _ _...._
II/coming AntEJnna 2.
or CabiD
Figure I0. Connecting an HDTV cable box or Satellite
Receiver with Component Video Connections
Chapter2. Connecting
29