Connecting A Satellitereceiver - Mitsubishi HS-U760 Owner's Manual

Chapter 2: Connecting YourVCR
18
€ Connectinga Satellite Receiver(optional)
If you have an RCA Satellite Receiver, you can connect the
receiver to your VCR. This will not only allow you to record TV
programs coming from the receiver, but it will allow you to control
the receiver through the VCR.
connecting a satellitereceiver
To connect the satellite receiver, you will need an S-Video cable
and one stereo audio cable. You can purchase, these cables at your
Mitsubishi dealer or at your local electronics store.
before you begin, you should:
• have completed all connections between :_our VCR, TV, and
cable or antenna; (see pages 12-17) and
• make sure that your satellite receiver has been installed
correctly. (See your satellite receiver's manual for more
information.)
O
Place the satellite receiver near your VCR so that there is an
open path between the remote control sensor on the receiver
and the Converter Box Transmitter on the VCR. (The Con-
verter Box Transmitter is the small window on top of the
VCR.)
O
Connect one audio cable to the left audio output terminal on
the receiver; connect the other end of the cable to the terminal
on the rear panel of the VCR labeled AUDIO IN 1 IAVIONO.
Connect another audio cable to the right ou:put terminal on
the receiver; connect the other end of this cable to the termi-
nal on the rear panel of the VCR labeled AUDIO IN 1 R.
BACK PANEL(VCR) BACK PANEL (Satellite receiver)
iCONVERTER
BOXCONTR_.J
• _ EDIT
!l
_ IN
ACTIVE
AN NETWORK
(_ OUT
(_R L(_(_ S'VIDEOOUT.
AUDIO OUT IVIDEOOff
I
S-VIDEO
IN
S-VIDEO--
2
3
i
,4
-- AUDIO IN L/MONO
AUDIO IN R
@®®®
VIDEO R AUDIO L
S-V, _)EO
__ The plugs on the S-Video cable contain pins that |
need to be aligned properly before the plugs can
J
be pushed into the terminals.