Mitsubishi WD-57833 Owner's Manual page 82

82 Appendices
A
Front-Panel Lock To re-enable the front- o Allows the front panel to be
Release panel controls after unlocked if the remote control is
activation of the Front- misplaced.
Panel Lock
o
System Reset If the TV does not turn on Press the SYSTEM RESET b utton on the front The TV will turn off and the green LED
or off, does not respond panel with a pointed object such as the will flash quickly for about one minute.
to the remote control or point of pencil or end tip of a paperclip. When the green LED stops flashing,
front panel buttons, or you may turn on the TV. The changes
has audio but no video, you made most recently, before using
SYSTEM RESET, may be lost. Changes
you made previously, however, are
not lost.
TV Reset To reset all consumer- 1. While viewing the TV, press MENU to The TV will start the initialization
IMPORTANT" accessible settings display the TV Main menu. process. The TV will then turn off
and the front green LED will start
Use this reset and all memories to the 2. With the Main menu displayed, flashing. When the LED stops
resets°nly if allhaveOtherbeen original factory defaults, press number keys 1 2 3 to display flashing, you can turn the TV on
unsuccessful. CAUTION: All owner- the Reset menu. again. The Parental Lock Pass code
performed setups and 3. READ THE ON-SCREEN will remain unaffected, but all other
adjustments will be WARNING AND iNSTRUCTiONS, memories and settings outlined in
erased. • If you do not wish to use this this Owner s Guide will need to be
reset, press EXIT or MENU to back set again.
out.
If you do wish to use the reset,
press ENTER to erase all memo-
ries and settings.
When Energy Mode is set to Fast
Power On, press and hold the MENU
button on the front panel for over
eight seconds.
When Energy Mode is set to Low
Power, press POWER on the front
panel to turn on the TV. Press and
hold the MENU button on the front
panel for over eight seconds.