Mitsubishi WD-57833 Owner's Manual page 8

8 1. Television Overview
Front=Panel indicators
0 off 0 Steady On 0 Slow Blinking
POWER/TIMER Indicator
P STATUS TIMER -- POWER
Fast Blinking [] []
None O TV is powered off. Normal operation.
Green (_ TV is powered on. Normal operation.
Green O TV powered off, auto-on timer is set. Normal operation. TV can be turned on at any time.
Green _ 1. TV just plugged into AC outlet. Wait approximately one minute for blinking to stop before
2. AC just restored after power failure, turning on. Normal operation.
3. TV rebooting after System Reset
used.
4. TV rebooting after power fluc-
tuation or receiving abnormal
digital signals from a digital
channel or digital device.
5. You have begun the procedure
to update software from an
authorized flash memory device.
STATUS Indicator
None O Normal TV on or standby condition. Normal operation.
Yellow _ TV is too hot. The TV will display a warning message and shut off if it overheats.
• Ambient room temperature may be too high. Turn off the TV
and wait until the room temperature drops.
Clear blocked air vents. Ensure at least a four-inch clear-
ance on all sides of the TV.
Clean the lamp-cartridge air filter. See Appendix B.
Red TV may require service. Turn off the TV and unplug the set from the AC power source.
Wait one minute and then plug the set back in. See Appendix E.
If the LED is still on, contact your dealer or a Mitsubishi
Authorized Service Center. Go to www.mitsubishi-tv.com or call
1-800-332-2119 to receive Authorized Service Center information.
LAMP Indicator
None O Normal TV on or standby condition. Normal operation.
Green _) TV just powered off and lamp is Starts to blink 30 seconds after turning off TV. TV can be turned
cooling, back on before blinking starts or after blinking stops, but not
while the indicator is blinking. Normal operation.
Yellow Q 1. Lamp access door is open or TV will not operate until lamp access door is secure. See
not secure. Appendix B for installation information.
TV will not operate without a lamp. See Appendix B for installa-
2. No lamp installed.
tion information.
Red _ Lamp no longer illuminates and has Replace the lamp. The TV will not operate when the lamp no
reached the end of the lamp life. longer illuminates. See Appendix B for installation information.